If that is what was being stated, I did not understand
"sends" equals "the paddles send OK".
If the KX2 is going into full transmit, there is a problem, contact
support for assistance.
73,
Don W3FPR
On 9/9/2017 4:04 PM, Don Butler wrote:
I think he may be saying that when the KXPD3 is fully inserted the rig goes
into transmit .... but it works properly when it is pulled out a little ...
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Don Wilhelm
Sent: Saturday, September 09, 2017 1:34 PM
To: Ignacy; [email protected]
Subject: Re: [Elecraft] KXPD3 problems
Ignacy,
I have no idea why you would want to operate it when not fully inserted and
the securing screws tightened.
It does not sound to me as though you have a problem.
73,
Don W3FPR
On 9/9/2017 3:02 PM, Ignacy wrote:
KXPD3 worked well until last week (ES/NO9E). Now as Z3/NO9E, KXPD3
sends when fully inserted. When partially inserted, it works OK. It
seems that the bottom pins in KX3 are a bit lower and the top ones are
a bit recessed. But perhaps it was always that way.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
