Don, Thanks for the walk through. With that and the manual I should be good to go. I appreciate the help.
73 de bill K7WXW From: Wilhelm Don <[email protected]> Reply: [email protected] <[email protected]> Date: September 23, 2017 at 7:16:05 PM To: - K7WXW bill <[email protected]>, [email protected] <[email protected]> Subject: Re: [Elecraft] KX1 rehab Bill, Dale gave a good answer, but did not include how to do it with the KX1. I can supply that. If you have the KXAT1 installed, pull it out and jumper between pins 1 and 3 of the 3 pin header next to the BNC jack. That connects the antenna with the KXAT1 not in place. If you have a wideband noise generator, connect it to the BNC jack - if not you can likely use an antenna - tune to a spot where there is only band noise and set the RF Gain to max clockwise and the bandwidth to a mid-point. Select 20 meters and tune CA and CB (marked 20A and 20B on the board) for a noise peak. If you cannot discern a peak, try it tuned to a moderate strength signal. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
