I am in the same situation and I just want to make sure that I fully
understanding what the solution is:
I have a K2 with the K60XV option installed and will use a XV50 for 6m
operation. I need to have no more than 10w being produced by the XV50 so I
don't fry my 6m brick. I would construct the XV50 and configure it to be
driven by a K2 with the K60XV module as per the instructions (1mW drive).
Assuming that the XV50 is set to be TRN1, I would set the OUT parameter for
TRN1 to .50 (.5 mW) - which would therefore make the max output of the XV50
10w. This would be independent on any setting of the Power control on the
K2. I this the correct procedure for limiting to output of the XV50 to 10w
based on my equipment configuration?
73
Dennis - WB0WAO
EN84ij Iosco County, Michigan
K2 #3555
_________________________________________________________________
Express yourself instantly with MSN Messenger! Download today - it's FREE!
http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
