Roger,
I assume you are using AFSK A data sub-mode. Check the data submode to
be certain.
Do you have anything other than the soundcard audio lines, the RS-232
computer connection, the DC power cable, the wattmeter and antenna (or
better yet a dummy load) connected to the K3?
If so remove everything except those items.
It appears you have the audio set about right, although the 5th bar
should be only flickering, not on solid.
Try again with the bare K3 and see what happens. If you have the KAT3
installed, do an ATU TUNE into the dummy load to set the L/C components
to match the dummy load.
73,
Don W3FPR
On 10/10/2017 4:37 PM, Roger D Johnson wrote:
I'm trying to get my system set up for RTTY. I think I have the cabling
OK. Using MTTY I can decode signals fine but when I try to transmit,
I get no power out. The MTTY program keys the VOX and I have 5
bars of ALC but nil on the wattmeter!
Help!
73, Roger N1RJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
