I have 2 KRC2's, one is working correctly with my K3. The second one
used to work, but now just blinks the LED slowly, about 1 sec. rate,
when powered up. If I switch the OP/DL switch to DL the LED turns off.
I have no comms over the serial port with my computer. I'm using the
same setup as the one that works.
I tried to D/L new firmware, but it never finishes and the symptoms
never change. Is the PIC16F877 fried, or the serial interface chip
(MAX1406)?
Any suggestions on what to try?
Thanks,
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
