Good Morning Bob, I’m not sure my problem is the same as yours. My PX3 is only 2 years old and I had never saved a configuration file to this point. Neither had I adjusted the amplitude and phase on the I and Q channels. I did that for the first time last night and, seeing it was recommended procedure, attempted to save the configuration. That is when I had the problem.
When the support folks at Elecraft have had their morning coffee, I will call and see what they have to say. Thanks for thinking along with me. 73, Dave, K4TO > On Oct 17, 2017, at 9:05 AM, Bob N3MNT <[email protected]> wrote: > > There was an issue with saving and recalling the configuration and memory > settings with the PX3 but I do not recall ever seeing a firmware update to > fix. The issue was during the last update, there was an oversight. The > file name for file was changed in one section of the code, but not in > another causing an error. This was some time ago so I will have to go back > and look at my solution. But it essentially meant that you saved the file > under the new naming convention, then had to change the name to the old > convention and you could recall it. > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
