Bob,
Select the K3 in Hamlib if the KX3 is not present in the selections.
Other than that I cannot help much with the computer end setup.
FT8 is no different than other soundcard data modes.
On the KX3 part, set the DATA mode to DATA A. Ignore the common
internet advice for setting the audio and power levels (and the WSJT-X
instructions), and set the KX3 audio level to indicate 4 bars on the ALC
meter with the 5th bar flashing. Control the power with the power knob.
There is an article on my website www.w3fpr.com to assist you with
setting the audio level. Scroll down to the bottom of the left column
and click on the link.
73,
Don W3FPR
On 10/20/2017 4:54 PM, Bob Cutter wrote:
New to FT8 and KX3 operation.
I cannot seem to get them communicating. Error message hamlib failure.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
