Actually the SA612 is a better part with better specs. Philips
replaced the SA602 with it.
On Apr 21, 2006, at 3:24 PM, Nigel A. Gunn G8IFF/KC8NHF wrote:
Same device, different number. Goo ahead and melt solder.
Bill Reid wrote:
The K2 manual lists SA602 for U1 on the control board and the part
number in my kit is SA612. Is this IC OK to install?
_______________________________________________
--
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
<><>
Nigel A. Gunn. 59 Beadlemead, Milton Keynes, MK6 4HF, England. Tel
+44 (0)1908 604004 mobile +44 (0)7765 471661
e-mail [EMAIL PROTECTED] www http://www.ngunn.net
Amateur radio stations G8IFF, KC8NHF
Member of ARRL, GQRP Club, QRPARCI, SOC #548, Flying Pig #385,
Dayton ARA #2128, AMSAT-NA LM-1691, MKARS, RAYNET
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
<><>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
-Jack Brindle, W6FB
=======================================================================
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
