Oscar,
Instead of checking for the maximum power output, check to see if you
have power control.
Operate into a dummy load - if you have the KAT2 installed, set the ATU
menu to CALP and exit the menu. Then set the POWER knob to 5 watts and
see whether the power output goes to something quite above 5 watts.
If the power is significantly higher than that set by the POWER knob,
then the K2 is not measuring the power output correctly.
If you have the KAT2, there is a problem with the wattmeter on the KAT2.
Most likely diodes D1 and D2 have been damaged by static coming from
the antenna feedline. Those diodes are the first thing to check.
If no KAT2, then D9 on the RF board is the most likely suspect.
73,
Don W3FPR
On 11/25/2017 9:09 PM, Oscar Castillo wrote:
hello all
i have a problem whit my K2, on 40 meters band i have like 22 - 24 watts of
power all the others bands are ok 13 - 15 watts on full power, and on SSB any
band i hit the mike i get the CAL CURR sign, any clue what the problem are?
thanks everyone for the advices
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
