I have a K3 which has been upgraded to have the Elecraft
internal USB sound card.
I tried adjusting the DSP bandwidth when running FT8 to
eliminate a strong signal above the FT8 subband and noticed that
there was a strong noise bar on the water fall for about 400 Hz
below the high cutoff. Further playing with the controls showed
a similar noise bar just above the low cutoff. Note that these
noise bars are in the requested pass band.
Has anyone else observed this noise? Does anyone have an explanation?
73 Bill AE6JV
-----------------------------------------------------------------------
Bill Frantz | There's nothing so clear as | Periwinkle
(408)356-8506 | a design you haven't written | 16345
Englewood Ave
www.pwpconsult.com | down. - Dean Tribble | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
