Nope - didn’t get that far in the manual. I was just too excited to read any more. Looks like those parts address my question pretty well. Thank-you much Don.
Jeff - KG7HDZ > On Dec 22, 2017, at 3:35 PM, Don Wilhelm <[email protected]> wrote: > > Jeff, > > Have you done the Opposite Sideband Nulling (page 26 in the manual). > Make certain the RX IQ plugs are fully seated at both ends. > See Trobleshooting on page 33 in the manual. > > 73, > Don W3FPR > >> On 12/22/2017 5:15 PM, Thorpe, Jeffrey wrote: >> Probably a dumb question. New to using pan adapters, and just got my PX3 put >> together. >> I hooked it up to my KX3, tuned around on 40m (using a home-brewed AS-2259 >> NVIS type dual dipole for 40m and 80m) and I get really strong signal >> indications close to 19khz both above and below the center frequency on the >> display. It doesn’t matter where I tune in the band. If I adjust the scale, >> the signals stay at the +/- point of about 19khz. They appear stronger than >> any other signal in the display. >> I am running the KX3 off internal batteries, and the PX3 off a LiFePO4. >> Are these signals from something outside being picked up in the cables >> between the KX3 and PX3, a problem with the PX3, or something else (like, >> maybe, me)? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
