I believe PWR SET in the CONFIG menu has to be set to 'Per band' for it
to save two power settings - one for barefoot, and one for amp
operation. It is on page 53 of the K3 Owners Manual.
Mike - KI0HA
On 12/24/2017 09:46, hawley, charles j jr wrote:
I updated the KPA500 to 1.54 and went to o=Operate on the amp.
The K3 displayed "Operate", but the K3 did not change the power to low drive
power. I do doubt if it had anything to do with the update.
Then I tried to set the power levels switching from Standby to Operate and
back. Still no joy.
Then I restored the K3 to an earlier configuration and all is well. Now the
power switches from low power on Operate to high power on Standby.
Is there some menu setting that can select whether that works or not?
I could not find one.
What could have happened to the K3 to keep that from working as advertised?
Chuck Hawley
[email protected]
Amateur Radio, KE9UW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
