I have a K3/100. For CW and RTTY below 10 m, I normally run a 20 KHz
span with the ends of the span on even 20 KHz boundaries [3500-3520,
3520-3540, etc]. I'm in Fixed Tune mode where the span edges remain
fixed and the VFO cursors move as I tune. Tuning off the edge results
in a full 20 KHz shift [IAW, a new 20 KHz span].
When I change bands using BAND UP/DN, the P3 seems to preserve this
configuration from band to band. The same seems to hold when I use
direct frequency entry. However, when running N1MM+, typing a frequency
into the call sign window will go to that frequency on the radio but
will put the span edges at odd 20 KHz boundaries [3510-3530, 3530-3550]
and sometimes at 3515-3535.
Does anyone know how the P3 recalculates the span edges on band changes
from an external control program? If I knew, I might be able to compensate.
73,
Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
