On Sun, Feb 4, 2018 at 17:45 John Woodard <[email protected]> wrote:
> I just installed the KXV3B board, upgrading from the KXV3A. When I went to > do the 1mW calibration at the end, the calibration failed because the SWR > was 2.9:1 on 52 MHz. I tried a couple more times, with different dummy > loads and cables and found the same result. > > > I then connected an external SWR meter to the dummy load and found that > the external SWR meter showed a flat 1:1 SWR with the dummy load (as > expected) but the K3 SWR value was always higher, typically 1.4 or 1.5:1 up > to 2.9:1 on 52 MHz into the dummy load. The tuner works perfectly on all > bands, however. > > > Has anyone had a similar issue? I can’t quite tell if the problem is in > the KAT3 or on the K3 main board, and more importantly what the fix might > be. Also, since the 1mW calibration failed, are there any other > workarounds? Many thanks in advance! > > > 73 de John, WK8A > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
