The router software should show if the K3 is connected. Make sure that this works before opening the logging software. Like others have said, use 38400 baud. Carefully follow the MicroHAM instructions.
John KK9A N6XI wrote: You got good advice on baud rate. Also, it's wise always to confirm proper operation with K3 Utility first. If it doesn't connect, chances are N1MM won't, either. Utility marches through speeds until it finds one that works. MM requires a specific speed setting. 73, /Rick N6XI Greg Best gbconsulting54 at gmail.com Thu Feb 15 20:33:43 EST 2018 I am trying to get N1MM+ to talk to my K3 but will not do it. I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS have been tried with both Always ON and Always OFF but neither one works. I have tried the Radio reset command from N1MM+ with no luck. Can anyone help? 73¹s Greg 16100 Outlook Avenue Stilwell, KS 66085 816-792-2913 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com