Thank you for the fast response.
In another email thread, I'm proposing a network interface for the K3
(with audio) that plugs into the same connector as the K-pod (but would
need an audio section as well for older KIO boards), which would make
the entire K-line network available; therefore (with some software
updates for management) much easier to remote without a computer to
manage the station.
Rick
On 2/21/2018 1:06 PM, Dick Dievendorff wrote:
This is planned for the next utility rev. Static IP was just recently added to
firmware.
73 de Dick, K6KR
Sent from my iPhone
On Feb 21, 2018, at 12:37, Rick WA6NHC <[email protected]> wrote:
Hello,
I normally run the KAT500 and KPA500 utilities on the computer than manages my
station.
I'm awaiting the arrival of the KPA1500 but in the meantime I read the manual
and download/installed the KPA1500 utility, which leads me to a request.
In one of the next utility iterations, could it include a network interface
made within the utility program so that instead of a serial port, the network
connector could be used?
Thank you,
Rick WA6NHC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
