I have finished to build my K3S but unfortunately I am experiencing some 
issue.Everything seems to work fine as no errors are showing in the display and 
when I did the TX gain calibration it went ok with no errors.I have the ATU and 
100W PA installed.Basically what is happening is, if I keep the power up to 12W 
everything is ok but when I increase the power (I hear the relay clicking to 
engage the 100W PA) the received signal just drops to almost zero.I have taken 
the PA apart again to check if there was any damaged pins but all looks ok.
Does anyone experienced this issue?
PS. The PA put out 100w as it should.
73, MatteoM0TKM

Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com

Reply via email to