I have a P3 with latest revision of firmware and an SVGA card and a station monitor and a USB keyboard plugged in as well. The frequency readout on the P3 and external monitor is correct under all common operating situation when I have a “span” of, say 100KHz. However, when I use the command sequence:- #CTF00000000000;#SPN00040;RCF+002000 which gives a span of 4KHz, centres the frequency and then effectively moves the filter area to the left there is a small problem. If I set the dial to 7.100KHz then apply the above command string (via a stored macro accessed via the USB keyboard) then the reading on BOTH the SVGA connected monitor and the P3 itself stow 7.100.0 at the left 7.100.00 middle and 7.104 at the right edge. Clearly this is not correct. Thoughts and observations welcomed. G4HUE, Andy
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
