Your right. When I used Xmit button and a foot switch for transmit and they worked just fine. So that means its HRD and the CAT control that is "causing" the problem. I have tried using both the K3 controls and the keypad macro and I get the same result with both.
I guess its a "feature" of HRD! Andy ----Original message---- >From : [email protected] Date : 25/02/2018 - 12:00 (GMTST) To : [email protected] Subject : Re: [Elecraft] Odd effect on the K3 when displaying REF*CAL Hi Andy, My K3 is equipped to use an external 10MHz reference. The display of REF*CAL implies yours is similarly equipped otherwise the display would be REF CAL. I have never thought to TX when in the Config menu and displaying the REF*CAL reading. However, I have now tried it, under both manual control using the XMIT button, foot switch PTT and CAT from my PC running Logger32 and in all cases it changes from RX to TX to RX as expected. Feel free to let me know if I've misunderstood your query. Quite happy to conduct further tests. Regards, Mike VP8NO On 24/02/2018 18:52, ANDY NEHAN via Elecraft wrote: > I use HRD to control my rig on data modes and it does a good > job and works as expected. However, if the K3 display is set to show the > REF*CAL situation then after transmitting the rig stays in transmit mode, as > shown by the > red TX button being lit. I have not noticed this when the K3 display shows > other information such as the current being drawn. > Is this to be expected?? > G4HUE Andy > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
