Hello to the group. I am having an issue trying to get my K3 Utility program (Version 1.16.7.25) to connect to my K3s locally.
I am using a remote rig system and am attempting to program the K-Pod macros at the control site. The Remote rig system creates three COM ports. I have COM 6 as my CAT port. If I turn the K3/0 mini on and then launch my N1MM+ software, the software connects to the K3s on COM 6 and I have CAT control of the radio. When I then launch the K3 Utility program and select COM 6 even before attempting to press the Test Communciations button, the top banner message I see is : "Elecraft K3 Utility Revision 1.16.7.25 on COM 6 closed". I am almost certain that I may have hit the Close Port button below the Test Communications button at some point and then encountered this problem but not sure. I have attempted to reset the Remote rig units, the K3s/0 mini as well as my computer with no change. Not quite sure what to try next. Any assistance would be appreciated. Please let me know if any additional information is required. Thank you in advance. Serge VA3SB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
