Chris,
Which filters are enabled for what modes? You can check with K3 Utility.
It would simplify things a bit if you moved the SUB RX filter by one
slot (leaving FL1 empty).
Then change the filter configuration to match using either K3 Utility or
by hand in the menu.
The thing that is really important is that you enable the filters for
the intended modes.
The display of FL1-FL5 normally refers to the main RX. Use BSET to
display the filter for the subRX.
73,
Don W3FPR
On 3/13/2018 11:08 AM, Chris Hallinan wrote:
Hmmm.
Just made a new discovery.
I can get the Sub RX to work on FL2 and FL3, but not FL1 nor FL4.
Here is my filter configuration:
FILTER Main RX SUB RX
FL1 13KHz 2.7KHz
FL2 2.7 1.8
FL3 1.8 500Hz
FL4 500Hz 250
FL5 250Hz
First of, shouldn't these match for proper diversity receive? ie same
filter bw in corresponding slots?
Second, the SubRX *WORKS* again on 20m with FL2 or FL3 selected, but not
FL1 nor FL4.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
