Mark, while you have the probe in TP2, also check the BFO frequencies for CW FL1 thru FL4 and include them with the info you send.
73, Don W3FPR > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Mark Bayern > Sent: Thursday, May 04, 2006 6:07 PM > To: [EMAIL PROTECTED] > Cc: [email protected] > Subject: Re: [Elecraft] K2 Part II Alignment Probs > > > > Can you be specific about how you are determining that the BFOs > are on the > > wrong side of the carrier? > > I'm listening to the 7.040MHz generated by an XG2. When I have CW > (not R) selected the pitch goes down as I turn up in frequency. > > I'll give you the BFO high & low freqs and the marking on the crystal > envelope when I get home in an hour or so. No KSB2 yet. I'll add it > after the basic rig works. > > Thanks for the response. > > Mark > > > > > > Using 40 meters, tune in a signal, then tune the pitch of the > signal to a > > lower tone, observing which way you turn the VFO dial - if you > have LSB or > > CW selected, the pitch should become lower as you tune lower in > frequency - > > USB and CWr will be the reverse. > > > > If you indeed do have inverted sidebands, then re-check the BFO > range test > > and let us know what the high and low BFO frequencies are. and > let us know > > the number (x.x) that was marked on the envelope your crystals > were packaged > > in. > > > > Also, do you have the KSB2 installed yet or not? > > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.392 / Virus Database: 268.5.3/331 - Release Date: 5/3/2006 > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
