I decided to hook my dummy load to antenna two on the KAT500 with my main antenna being on antenna 1. When I get a strong signal on my main antenna and switch the KAT500 to port 2 (dummy load) the KAT500 I can still copy the signal on my K3S though the strength is down from S9+ to about S2.
I can keep the KAT500 on antenna 2 (dummy load) and disconnect the dummy load from the back of the KAT500 and still hear the signal. I was using an Alpha Delta 4 port coax switch to switch between my main antenna and a dummy load. All was well. No signal being heard when I switched to the dummy load. In this configuration I had antenna 1 from the KAT500 going to the Alpha Delta switch and then out to my antenna. —————— 73, Tom - KQ5S ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
