Hi Noel, I can share my settings which work just fine with TS480 (it should work also with TS590 models)... N1MM talks just fine with the radio with KRC in the middle
You need some small modification inside KRC2.... Here are the settings for 19200 baud-rate Jumpers IN: 3, 6, 8, 9, 10, and 21, 22, 23 Jumpers 14 & 17 bridged with voltage from pin 7 of U2 fed to this jumper (~2" piece of wire). Hope it will solve your problem, try it and report back 73 Robert, S57AW On Tue, Mar 27, 2018 at 10:12 PM, NOEL POULIN <[email protected]> wrote: > Hi, > I am having a hard time with the KRC2 band decoder jumper settings for a > KENWOOD TS590SG.. > Here is my setting according to the KRC2 manual (page 23)..for kenwood > radio pc logging in use, data rate 19200 bps > INSTALLED REMOVED > w3,w6,w8 w1,w2,w7,w11, > w12,w13,w14,w15,w16,w17,w18,w19,w20 > w9,w10,w21,w22,w23. > No luck with settings...... > The logging software is talking to the radio when the decoder is not > between the radio and the pc....but when I connect the KRC2, no results, > the logging software can't talk to the radio at all.... > > What have I done wrong ??? > Help will be more than welcome... > Many thanks > Noel > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
