Anything special about the thermal pads they recommend or the placement of the pads? Is there anything on the Elecraft site I missed on this? Tnx N2TK, Tony
-----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Brian Hunt Sent: Wednesday, March 28, 2018 7:24 PM To: Elecraft@mailman.qth.net Subject: Re: [Elecraft] K3 powers off when after several minutes of 12W carrier For folks who run lots of high duty cycle modes, Elecraft is now recommending 'thermal pads' between the LPA transistors and the bottom cover. I found this out when I was doing some mods to my 10yo K3 and the instructions said to install them and I didn't have 'em. You can get them from Elecraft, not expensive. 73, Brian, K0DTJ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to tony....@verizon.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com