Bob
This is a macro command so does not appear in the config or menu. Take
a look at page 27 of the Programmer Ref. You can use the command tester
in the Utility to try it out.
Just for reference here is the Programmer Manual reference
TM (Transmit Meter Mode; GET/SET; K3/K3S only)
RSP format: TM0; (SWR/RF metering) or TM1; (CMP/ALC metering). This
sets the transmit meter mode for
the LCD bargraphs, as well as for the BG command (equivalent to using
the METER switch). When TM0 is in
effect, BG returns the RF level. When TM1 is in effect, BG returns the
ALC level.
73 Dave K5MWR
On 4/2/2018 9:05 PM, Bob McGraw K4TAX wrote:
Is this feature new or unique to the K3 but has been resident for the
K3S? If not, I haven't found the TM command in either the Menu or
Config of my K3S.
73
Bob, K4TAX
K3S S/N 10163
Firmware update
K3 MCU 5.62 / DSP 2.88 / FPF 1.26, 11-16-2017
* NEW CONTROL COMMAND (TM): The TM command sets or reads the transmit
metering mode on the LCD. TM0; sets the bar graph for SWR/RF, while
TM1; sets the bar graph for CMP/ALC. The TX metering mode also
determines what is read by the BG (bar graph read) command during
transmit. With TM0 in effect, BG reads the power level. If TM1 is in
effect, BG reads the ALC level.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
