Hi, do not worry, nothing goes wrong with your KXFL3 when last 2 pins are removed.
The removing pins (10), 11, 12 is the hardware modification described below as an alternative for those who have the KXFL3 module... See KX3 VFO Tuning Noise Suppression Modification: http://www.elecraft.com/manual/KX3%20Tuning%20Noise%20Mod%20rev%20B3.pdf "If pins 11 and 12 of the 12-pin connector have been removed from the board, the KXFL3 has been modified. Even though the modification discussed in this document removes a third pin as well, the factory's mod achieves the same results by removing a component from the PC board." Hope it helps, 73 - Petr, OK1RP (ex KL7/OK1RP at Fairbanks/Prudhoe Bay) ----- http://ok1rp.blogspot.com -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
