Hi Kurt,
It's hard to tell because the monitor plays the KX3 audio, which is good. Tnx, Ray -----Original Message----- From: Kurt Cramer <[email protected]> To: rsoifer1 <[email protected]> Cc: elecraft <[email protected]> Sent: Mon, Apr 23, 2018 8:58 am Subject: Re: [Elecraft] KXPA100 SSB Distortion Does it work correctly into a dummy load. It sounds like RF in the audio, 73 Kurt W7QHD > On Apr 23, 2018, at 8:32 AM, Ray W2RS via Elecraft <[email protected]> > wrote: > > > My KXPA100 transmits distorted audio on SSB, but works normally on CW and > RTTY. With 100 watts output, drain current is 11.7 A and supply voltage is > 13.1 V, down from 13.7 V on receive. My power supply is a pre-MFJ Astron > RS-35A. > > > The KX3 with which I drive it operates normally on all bands and modes, with > good transmit audio. Speech compression is off and mic gain is set to 20. > > > Should I send the amp back to Elecraft for service, or is there another > problem? > > > 73 Ray W2RS > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
