I’m assuming you do have a KXV3 installed? Make sure you’re not in BSET or VFO A/B REVerse when you send the command.
Also try sending just “AR;” in the command tester and see if you get a response. If you don’t, then you must have older firmware without the command implemented. 73, Wayne N6KR > On Apr 26, 2018, at 6:29 PM, Rich - K1HTV <[email protected]> wrote: > > I have been unsuccessful in being able to control the K3 "RX ANT" using > macros with either the AR1 (on) or AR0 (off) commands. Manually tapping the > 'RX ANT' button on the K3 will correctly toggle the K3 receiver between the > MAIN and RX ANT (Beverage) antennas. > > > Using the latest version of the K3 Utility I verified that the K3 has the > latest version of firmware and that it responded to a number of commands, but > it would NOT respond to either the 'AR0' or 'AR1' commands. The K3 is SN 3657 > with sync and the KIO3 USB upgrades. > > > Thinking that there may be an EEPROM corruption problem I did an EEINT > factory reset. After changing the CONFIG 'RS232' setting back to 'USB' so the > K3 Utility could communicate again with the K3, I reloaded the last backup of > the configuration settings. I still could not get the AR0 or AR1 commands to > switch the RX ANT on the K3. > > > Any suggestions as to how to get the 'AR0' and 'AR1' commands to work so I > can use them in a macro? Could I have a bad EEPROM? > > > 73, > Rich - K1HTV > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
