Hi,
I am about to start replacement of the LPA output devices. To do so I
think I first need to remove the KPA3. Once done can I just operate the
K3 at low power to prove the LPA? I don;t have the jumper block so would
just leave the interface block in place. I'm assuming it does much the
same thing at low power .
Is there a procedure of any sort I can follow?
What bias current should I set R18 and R19 for?
Thanks
Martin, HS0ZED
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
