This didn't seem logical or possible to me. So I tried it and discovered the problem occurred on 6m, but not on 80m with my K3 and firmware 5.64. Interesting. This K3 (S/N 08343) has a recent EE INIT and re-load of firmware and configuration after experiencing a power overshoot issue (now solved).
73, Bill, K8TE President, Albuquerque DX Assn. ARRL NM SM (elect) Duke City Hamfest BoD www.dukecityhamfest.org Faith, Family, Radio-Life is Good! > >> On Nov 16, 2017, at 3:50 AM, Michael Eberle < <http://elecraft.365791.n2.nabble.com/user/SendEmail.jtp?type=node&node=7635 987&i=0> [hidden email]> wrote: >> >> Was this issue ever resolved? I have noticed the same thing with mine >> although the issue does not appear to be the tuner itself, but the K3 is not >> transmitting any power so the tuner has nothing to work with. I am running >> FW version 5.60 an have this issue but only on 6 Meters. >> >> I can power up the K3 and open WSJT-X on my computer and select 6 meters >> which usually causes SPLIT to turn on. Hold TUNE and the TX keys and the >> display shows 0 power. Turn off SPLIT and it puts out power as usual. Then >> if I turn SPLIT back on, it will then output a carrier as usual. >> >> If SPLIT is enabled on 6 meters and you run a TX gain calibration, it will >> fail the calibration because the TX puts out no power. >> >> It's not a major issue but an annoyance since I tend to forget about it >> every time I switch from HF to 6 and try to check my antenna tuning. >> >> Thanks, >> Mike, KI0HA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
