When we next release K3 firmware, the message flashed on VFO B will be “KPA*500”, intended to convey that either a KPA500 or KPA1500 is connected. At present the K3 doesn’t distinguish between the two, since they’re identical as far as operating state and error messages are concerned.
73, Wayne N6KR > On May 28, 2018, at 7:30 AM, Bill Stravinsky via Elecraft > <[email protected]> wrote: > > I'm thinking there will be a firmware update to fix this. I don't have a Y > box but the only menu choice in the K3 is kpa500 and that is what I see from > the 1500on the K3 display although it might already be fixed as I haven't > upgraded firmware in a while. > BillK3WJV > > On Sunday, May 27, 2018, 8:08:40 AM EDT, Bill via Elecraft > <[email protected]> wrote: > > Using N6TV ‘s “Y-Box,” I can switch between the KPA500 or my new KPA1500 > effortlessly as needed. However, regardless of which amp is active, the K3 > message that informs you that the amp has been switched to/from stand-by to > active always reads KPA500. > For someone running amps in the same configuration remotely, this maybe an > issue. > Has anyone else noticed this? > If so, have you determined a remedy? > > Thanks, > Bill-W0BBI ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
