It was not until recently that I acquired the TMP connectors and crimp
tool to make a proper jumper cable from my K3s' J1 connector on my K3s’
TXCO (TMP) to my frequency counter (BNC), so I have always used the
"zero-beat" method. Periodically, I go back and repeat the TXCO
calibration using a modified "Method 2 (Zero-Beating)" procedure (K3s
Owner's Manual, Rev A1, p.53). It originated (and grew) from a post
snippet from this reflector. (Thanks Scott, K9MA) IF you have an
Elecraft P3 Panadapter, or other, connected to the K3s’ IF Out, you can
use it to great facility in visualizing and verifying what "is" and what
you "do". I have written this procedure with the assumption that the P3
is not present or is not being actively used beyond observation. I may
write an addendum later to include the active use of the panadapter vs.
as an observational tool only.
For obvious reasons, the manual says to use the highest WWV frequency
available, and references 10, 15, and 20 MHz. Just in case you missed
it, NIST put WWV at 25 MHz back on the air sometime in 2015, but they
switched it to circular polarization around July of 2017. Link:
http://www.arrl.org/news/wwv-25-mhz-signal-swapped-to-circular-polarization
OR, back to the half-wave dipole depending on which reference you read.
<confused> Point is, that I am having great luck using it as a
reference signal.
Of interest to some may be the inclusion of a very simple equation that
tells you how much and which way to adjust REF CAL in one shot. No
fuss, no muss, no futzing around and back and forth. You make one
observation, one calculation, one input and you're done. (Usually)
MOST of the procedure is in the setup.
Go here to grab a PDF of the DRAFT document of the procedure I use:
http://www.montac.com/pdfs/Elecraft_K3_Zero_Beat.pdf
73,
--
______________________
Clay Autery, KY5G
(318) 518-1389
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
