I just contacted them this week for a broken AF knob and they said they
were sending a couple at no cost.
73,
Mike KI0HA
On 6/8/2018 08:14, Don Wilhelm wrote:
Linas and all,
I don't know if the policy is still in place, but several years ago,
Eric stated that defective knobs would be replaced at no cost.
Contact Elecraft support.
73,
Don W3FPR
On 6/8/2018 8:25 AM, Linas Balsys wrote:
The same is here. It is the crack in the knob, I can see it. You can
try to
tighten up the screw a bit but not too much not to finaly break the
knob.
If it is not completely loose you still can find the end stop while
turning
very gently and slowly. The best way surely is to get the knob
replaced :)
73 Linas LY2H
<<It's taken me 8 years to finally "break" something. Well it's
not....>>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
