Mark,
The only way I know of to do it reliably is to replace the inductor.
I suspect you stripped the threads on the inside of the inductor core
and not the slug. So just bite the bullet and replace the inductor.
73,
Don W3FPR
On 6/17/2018 11:41 AM, Mark Petrovic wrote:
While performing the IF alignment on my K2 s/n 7809, I must have backed the
slug on L34 too far up against the can. Now the slug doesn't move when I
turn it one way or the other (at some point I was able to advance it
downward to the 1/2 way point). Is there any way to re-index the slug onto
its threads so I can avoid replacing L34 and the desoldering that goes with
it?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
