Are you using PTT in CW or QSK/VOX?
Which cable are you using between MK II and the K3 - DB37-EL-K3R
(rear panel mic) or DB37-EL-K23 (front panel mic)?
Which PTT output is selected in microHAM USB Device Router for each
mode - PTT1 (mic PTT) or PTT2 (ACC jack PTT)?
73,
... Joe, W4TV
On 2018-06-24 5:19 PM, Peter Dougherty wrote:
Hi guys,
I think I may have either misconnected something or blown the PTT line after
re-connecting my K3s from stand-alone Field Day mode back to being integrated
into my main shack using MK-II hardware. I cannot assert PTT to the radio via
any means except manually using the XMIT/tune button or CW keying via the
paddle. My footswitch, handswitch and MicroKeyer-II PTT controls are all
inactive, and I'm in a bit of a panic since I know I didn't change any wiring; I
just disconnected everything to bring it outside yesterday.
Any ideas where I can start to look?
For any of you MK-II users, I have the MK-PTT IN line going to the KEY OUT jack,
and the wire marked PTT-IN going to the PTT-IN jack. The MK-II will put the
radio into transmit for CW, but not for RTTY, voice keying or any digital mode.
I'm beginning to think I may have damaged the radio at this point and could
urgently use some assistance.
----------------------------------------------------
Regards,
Peter Dougherty
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
