Brian,
We were in a high noise area and yes, I had the NB on. {'-) I
suspect that was the "muffled" artifact I was getting, but the "ghost"
signal, I'm not so sure about! {'-) All I know is that I'd call on one
of them, and they'd usually answer. Sorry I didn't pay any closer
attention to the spacing and such. Might be a clue for someone
attempting to eliminate the issue!
k WB9FMC
On 6/27/2018 10:40 AM, Brian Hunt wrote:
Did you have the NB on? I've noticed on my KX2 (similar h/w and firmware) that
using the NB with very strong signals close by will create all sorts of
artifacts like CW being sent using a highly damped bell. Turn off the NB and
it's clean as a whistle. HTH
73,
Brian. k0DTJ
Our setup was in, unfortunately, a fairly high noise area. I was working 20 CW. The
noise level was S3, with times reaching S6. I believe, "normal" would be closer
to S1. And, of course, lots of signals all over the board signal strength wise. Many of
them very strong (10 to 20 over 9!).
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
