Correct antenna selection is controlled by setting up the tuner using
the utility program. Each band can select up to three antennas to use.
One of the options is 'Last Used'. That may apply to your station.
Antenna selection cannot be determined without using the utility.
If your antennas are multiband, the tuner can be taught which antenna on
which band(s).
If the tuner is not programmed for a specific antenna on a given band,
you cannot override it from the front panel, this is logical and
protects from accidental choices.
Once you have the selection correctly set (SAVE) you can 'teach' the
tuner on each antenna on each band segment, per the manual. It will
remember (use save in the utility).
The time you take to correctly program the tuner saves you hours of
grief later. It's time WELL spent. Then leave the tuner set in manual
mode so it doesn't attempt retuning if something occurs during use (a
branch brushing a wire, an unfortunate bird action).
I DO suggest that you (after complete setup) at least glance over to
the SWR LED display during operation to ensure things are as you expect,
even after some time of successful use.
73,
Rick wa6nhc
On 7/3/2018 9:39 AM, Dennis Moore wrote:
Manual/Automatic is not used for overriding antenna selection, it
turns on or off the automatic initiation of a tune cycle when high SWR
is detected for the antenna that is currently selected. Many users
will tune each of their antennas on separate bands using automatic
then switch it to manual so that it doesn't attempt to retune that
antenna again.
73, Dennis NJ6G
On 7/3/2018 08:52, ANDY DURBIN wrote:
I have a new KAT500 and am learning how to use it. I have set up the
antenna switching table in the expectation that the table will be
followed when I'm in Automatic mode. However, I find that the
antenna switching table is also in effect when I'm in Manual mode. I
cannot manually select the antenna I wish to connect because my
Manual selection is overridden by the table selection appropriate for
the last transmitted frequency.
Why doesn't Manual mode give me full manual control? Why can't I
select the antenna I want to receive on without transmitting first?
Am I doing something wrong or is this an intentional limitation of
the firmware design.
Thanks and 73,
Andy k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
