Thanks, Don. Yes, I found I had to ream the existing hole *very* little, maybe one or two 1/100 of an inch, for the jack to pass through without forcing it. The difference did not feel like extra paint; it felt like the hole was in fact just a bit too small.
On Thu, Jul 19, 2018 at 8:49 AM Don Wilhelm <[email protected]> wrote: > Mark, > > The jack *should* fit through the hole, but I also know that it does not > with the jack supplied. > So ream out the hole in the top cover. I use a thin bladed knife, but a > drill bit or a proper reamer will work. > You only have to take a little metal from the inside of the hole. > > 73, > Don W3FPR > > On 7/19/2018 11:00 AM, Mark Petrovic wrote: > > In the top cover for my K2 S/N/ 7809, the external speaker hole is way > too > > small for the jack to pass through. Is it the design intent of the K2 > that > > this jack be screwed in? Or should it pass through without forcing it? > Or > > does it matter? > -- Mark ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
