Clay,
On your K3S, did you try plugging into the rear phones jack? You can do
that without any 1/8 inch to 1/4 inch adapter.
The resistance of each earpiece should be easy to check with your
ohmmeter and be revealing if there is a cord problem. The left channel
(tip) should compare with the right (ring) unless something is open or
shorted.
73,
Don W3FPR
On 7/24/2018 4:23 PM, Clay Autery wrote:
Anyone ever had a ProSet two fail to deliver two channel output when
everything is set up correctly (aka bad cable or failed R channel solder
joint at one end or the other)?
My Elmer has a set bought in April of this year and has never been able
to get right channel. I took it today to try on my K3s with known good
setup for 2-channel into phones (Sennheiser HD598SE).
Same problem on my radio... no right channel. Almost HAS to be 1)
solder joint failure on one of the wires to the driver, 2) a right
channel (+) solder failure at the 1/8" TRS, 2) failed right driver. It's
a non-coiled three cable-bonded cord... so I am assuming 3 conductors
with shields for ground.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
