The P3 has an IF Out jack. I have connected that to a SDRPlay RSP1 with good results. No splitter or tee required. You must flip the little switch on the back of the P3 to enable IF Out. On Thu, Jul 26, 2018 at 9:14 PM Leroy Buller <[email protected]> wrote:
> Part number? > > Lee > > On Thu, Jul 26, 2018, 8:45 PM John Simmons <[email protected]> > wrote: > > > You should use a splitter with isolation. Mini-Circuits sells them. > > > > -John NI0K > > > > Leroy Buller <[email protected]> > > Thursday, July 26, 2018 8:38 PM > > Stupid Question of the Month..... > > > > Is it possible to use a BNC T to drive P3 and a SDRPlay at the same time? > > Is there enough drive to do this? > > > > Back to your regular programming. > > > > Lee K0WA > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] <[email protected]> > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > Message delivered to [email protected] > > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
