Hans,
Does the USB to RS-232 cable have an FTDI chipset? I know that works OK
with the K2 (at least the one used in the KUSB). Others fail with the
slow 4800 baud rate required by the K2. I have had good success with my
Edgeport serial converter as well. A Prolific chipset adapter may or
may not work.
You still need to build a cable having only 3 conductors to isolate the
non RS-232 pins from the serial port, even though it may be short. The
AUX IO to PC cable is shown in the KIO2 and the KPA100 manual.
73,
Don W3FPR
On 8/6/2018 10:35 AM, Hans J Rasmusen via Elecraft wrote:
All,
During the past weekend I pulled my faithful K2 out for the EUHFContest.
I found a RS232 to USB cable locally, but it does not connect. Is there a way I
can check if the chip works correctly?
I have a couple of KXUSB on hand. Is there any reason that I can not or should
not connect the KXSUB Tip to Pin 3, the Ring to the Pin 2 and the Sleeve to Pin
5 of the DB9F connector (from the K2)?
I should then be able to key and control the K2 from N1MM logger, as I do my
KX3.
By the way, the K2 CW sound beats all, my KX3 included.
Thanks 73
Hans Jørgen (Joe)
OZ7BQ
Sendt fra min iPhone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
