Configuration page of the utility, “Initial Power” tab. Uncheck “Power On when DC power applied”.
Ken K6MR ________________________________ From: [email protected] <[email protected]> on behalf of Allen Bush via Elecraft <[email protected]> Sent: Wednesday, September 19, 2018 4:46:25 PM To: [email protected] Subject: [Elecraft] KAT500 question My KAT500 turns on by itself after a power outage. I can then turn it off and it stays off until another power outage. I am using a regulated wall wart to power it. Is this normal behavior? I keep it powered continuously but normally turned off. Allen, W0OUU ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
