Did you use set CONFIG:TX INH to Lo=Inhibit? What are you connecting to K3 ACC pin 7 to inhibit transmission? Did you supply 5V to that pin through a current limiting resistor or did you get it from Pin 1?
For a safe sample SO2R TX inhibit circuit, see https://bit.ly/K3lockout . But perhaps all you should do is increase CONFIG:TX DLY or your PTT IN delay. 73, Bob, N6TV On Wed, Nov 7, 2018 at 12:47 PM John Stengrevics <[email protected]> wrote: > To provide enough time for relays protecting a preamp to switch, I have > enabled TNX INHIBIT on the K3S. > > Does anyone know if operating WSJT-X disables TNX INHIBIT or effects it in > any way? > > 73, > > John > WA1EAZ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
