At one point, CMP would reset whenever I changed bands on my KX3. I did an EEINIT and reloaded the config, which fixed it.
Make sure you have a saved config before you EEINIT. The radio needs the config values to work properly. wunder K6WRU Walter Underwood CM87wj http://observer.wunderwood.org/ (my blog) > On Dec 5, 2018, at 4:38 AM, Gerry leary via Elecraft > <[email protected]> wrote: > > Hello everybody, I have found that at least in my KX three the equalizer > settings appear to be negated when I turn compression on. Even if I set them > really strangely with compression off, it goes back to whatever it was when I > turn compression on. So I guess what I’m trying to say is no matter what I do > with the equalizer, compression seems to negate it. > > Sent from my iPhone this time > > On Dec 4, 2018, at 10:14 PM, Jim Brown <[email protected]> wrote: > > Speech compression and EQ to get rid of the lower octaves of speech is a > wonderful thing, and can increase "talk power" significantly. My starting > point with TXEQ for maximum talk power is max cut of the three lowest bands > (-18dB), 6 dB cut of the fourth band, 3-6 dB of boost on the top two bands. > Do that BEFORE setting compression. > > But EXCESSIVE use of compression can be a very BAD thing. I'd be very > cautious about using more than an indicated 1-2 dB on voice peaks. It should > NOT be adjusted to a certain number on the CMP readout, but rather to the > meter that shows gain reduction. > > Once these settings are done, get signal reports from trained listeners, and > tell them to set their RX bandwidth fairly wide. > > These two settings -- good low cut of voice frequencies and 10 dB of > compression can increase talk power by 13 dB. That's multiplying your > effective TX power by 20! > > 73, Jim K9YC > >> On 12/4/2018 7:45 PM, Wayne Burdick wrote: >> Speech compression can add a lot of "punch" to your low-power signal, >> bringing up average voice power. As with the K3/K3S, our KX-line compression >> algorithm is exceptionally clean. Use the CMP switch on the KX3 (TX CMP menu >> entry on the KX2) to dial in compression of up to 30 dB. >> >> >> *** Receive and Transmit EQ *** >> >> 8-band graphic equalizers (MENU:RX EQ and TX EQ) can be used to tailor the >> receive and transmit audio to your liking. > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
