Eric,
Are you operating with the KAT500 in AUTO mode?
If so, after "training" the tuner across the band of interest with any
one antenna, change it to MAN mode and it will not try to re-tune.
As you said, the KAT500 follows the K3 VFO, so there should not be a
need for any retuning.
The problem is that the forward and reflected powers cannot be read
simultaneously. So if the forward power is read when the power is low,
and the reflected power is read when the power is higher, an erroneous
SWR calculation will result.
73,
Don W3FPR
On 12/13/2018 9:19 AM, eric norris via Elecraft wrote:
I am using an early KAT500 with a K3S. When using WSPR in band-hopping mode at
5w, WSJT-X 2.0 commands a band change and transmit, the K3S starts
transmitting, then stops, changes bands, then changes back to the original
band, say 40 meters. I think this part is a WSJT problem, and has been
reported. Now the K3 is on 40m. If I press the TUNE button in WSPR, the SWR
meter shows a high SWR and relays click in the KAT500. If I press TUNE again,
the swr is good.
The KAT500 is configured to follow the K3 vfo, so why is the KAT500 retuning?
If the K3 shows 40m, why wouldn't the KAT500 have the proper tuning solution?
It is properly cabled with auxbus cables between the K3, KAT500, and KPA500 in
that order (the KPA500 is off). The KAT3 is in bypass mode. I don't think
this is an rf problem because I regularly use the KPA500 with no signs of rf
getting into anything. This seems very odd. All firmware is current. Any
ideas?
73 Eric WD6DBM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
