I just powered up the K2/100 for the first time with the low-currnet
power supply and did the initial voltage checks on page 43.
D13 cathode was 143 v
U4 pin 8 was -25.54v
TP1 was 0v
J3 red lead was .091v
The manual says that J3 should be zero, Is this ok or am I too picky?
The current drain was 450 ma going down to 360 when I heard the fan go off.
K2 serial 4472
Jerry , N2UZ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
