John,
The Key Out signal is on the ring contact of the ACC2 jack. You will
need a 2.5mm stereo plug. Of course the shell is common, and the tip is
the GPIO - see page 5 of the KX3 manual.
If you have both the KPA500 and KAT500, the Key Out signal must connect
to one of the AMP KEY jacks on the KAT500 first, and then use an RCA TO
RCA cable to connect from the KAT500 to the KPA500 Key IN jack.
73,
Don W3FPR
On 12/20/2018 3:18 PM, John Pierce wrote:
I recently purchased a KPA500 with the cable to connect to the KX3. Can
someone tell me where the plugs on cable that connects the KPA100 amp plug
into the KX3? I have been told that that cable can be used to connect to
the KPA500 without the frequency control.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
