I probably will be doing the resistance checks later this weekend on the K2 control board. I know another one of my questions again. I have not done resistance checks on circuit boards in many years and I have hit a wall with this. For example: the instructions say, Test Point P2 pin 1, Signal name 12V and resistance (to ground) greater than 10K. For the life of me I cant remember how to take these readings. It is probably something very easy, I just cant figure it out. I hope someone has some good instructions on how to take the readings. Thanks.
BILL COCHRAN BILL COCHRAN REAL ESTATE APPRAISALS, LLC 1430 N 12TH STREET CAMBRIDGE, OHIO 43725 PHONE:740-439-7058 FAX: 740-236-1560 AMATEUR CALLSIGN: N8PGX _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
