I drilled the middle holes out large enough to take a nut, then used epoxy resin to glue the nut into the heatsink. Works a treat.
73 Stewart G3RXQ On Fri, 26 May 2006 17:46:43 -0400, Roy Morris wrote: > I do not think the ovrsized screws are the answer for the K2/100. Over time > I don't believe they will remain tight if you go into the K2 enough times and > might even strip. For this reason I have never put a screw in that hole. I > am thinking of drilling a hole at the precise right place in the first > cooling fin, tapping the hole and putting in a long enough screw that will > hold. I don't think the screw would be noticable if it is the same color as > the other screws. What do some of you think about this? Roy Morris W4WFB _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
